Operation and maintenance elements of gear reducer

When using the gear reducer, it is necessary to make some preparations. I will talk to you about the key points and preparation points of the operation.

1. Before the gear reducer device is used, the shaft assembly needs to be cleaned, and the collision, pollutants and how to clean the shaft assembly need to be inspected.

2. The operating temperature of the gear reducer is about 0 to 40 degrees.

3. Check whether the matching size of the holes connected by the gear reducer device is appropriate. The gap between the small holes is about H7.

4. When using the gear reducer, block and replace the exhaust screw device when the position is good, so as to ensure the gas emission of the gear reducer device.

Gear reducer assembly

Whether the gear reducer is flat during assembly, the pressure is reduced, the structure of the button, etc.

Under random conditions, the external wheel of the hammer, including the output of the coupling device and gear, cannot be damaged.

Maintenance and application of gear reducer

During the maintenance and assembly of the gear reducer, it is necessary to check whether its operation is dexterous and convenient. When it is used, it is also necessary to test when it is empty. When it is operated, it is necessary to slowly increase the load carrying capacity.

The gear reducer can not exceed the limited load application.