Industry-news

The influence of humidity on the operation of ZQ1000-50-48.57-IIICA reducer cannot be ignored. In high temperature and high humidity environments (such as summer in Wuxi), water vapor intrusion is the core risk of lubricating oil emulsification, metal corrosion, seal failure, and reduced transmission accuracy. If not prevented and controlled, the equipment failure rate can be increased by more tha

The core installation principle of the ventilation cap of WP0155-60-B worm gear reducer is to install it at the highest position of the box, ensure that the ventilation hole is unobstructed, moderately tighten the seal, and remove the protective plug. The following are detailed steps and specifications: 1、 Preparation before installation Confirm specification matching: Check that the thread sp

The testing frequency of the sealing performance of the sound insulation cover of WPA120-40 worm gear reducer should be comprehensively judged based on the equipment operating environment, working condition intensity, and maintenance objectives. In conventional industrial applications, it is recommended to conduct systematic testing every 3 months, which is the optimal cycle after balancing mainte

The heat sink of JZQ500 soft tooth surface cylindrical gear reducer is the core component of forced convection heat dissipation. By increasing the surface area of the box to accelerate heat dissipation, the temperature of the reducer during operation is ensured to be within a safe range. Loose or damaged heat sinks can directly damage the functionality of the heat dissipation system, causing chain

The impact of WHT08-63-8Z gearbox body material on noise is indeed a key factor in equipment noise reduction design. From the acoustic properties of the material itself to the structural stiffness, it directly affects vibration transmission and noise radiation levels. Based on current engineering practice and simulation research, cast iron enclosures have better noise reduction performance than ca

The specific manifestations of poor contact of gears in ZLY160-20.1-2 reducer can be divided into three categories: visual inspection, operation status, and long-term deterioration, which are convenient for technicians to quickly identify and judge: 1. Abnormal appearance of spots in color detection Tooth length direction: Spots are concentrated at one end of the tooth (near the shoulder or

The center distance deviation (including positive and negative deviations) of ZLY200-9-1 reducer gears can directly damage the normal meshing state of the gears and cause a series of transmission failures. The specific problems are as follows: 1. Serious and poor gear contact spots Positive deviation of center distance (actual distance greater than design value): When the gears mesh, the bac

The structural auxiliary measures of CWS200-12.5-SZ worm gear reducer mainly include improving transmission accuracy, improving lubrication conditions, enhancing heat dissipation performance, and ensuring sealing reliability, aiming to improve the operational stability and service life of the equipment under complex working conditions. 1、 Optimize tooth profile design to enhance meshing perform