Talk about how to maintain and "smooth" the reducer
Now many customers are using the reducer to buy the device, and then use it. If the reducer is broken, change it again. During the warranty period, the quality of the reducer is not required. Replacement and free repair are required. About this customer, we are Very speechless. The reducer also needs maintenance, just like we bought a car, how many kilometers to change the oil, how many companies to maintain, the same reason, the reducer is also to be maintained. So how to maintain it, let me talk about it.
1. Check the basics of the device, seals and drive shafts regularly. 2. If it is used normally, always check the oil level of the lubricating oil (observed through the oil window), the maximum temperature of the lubricating oil should be less than 85 °C. When the oil temperature rises abnormally, and abnormal noise occurs, it must be stopped immediately. After the fault is eliminated, it can be used continuously. 3. Replacement of new spare parts must be officially applied after running and load testing. 4. Do not hammer the casing of the reducer by gravity to avoid damage. Second, the use of lubricants to view and replace: 1, the operating environment temperature of the reducer is -40 ~ +40 °C. When the ambient temperature is below 0 °C, the lubricating oil must be heated above 0 °C or a low freezing point lubricant before starting. 2. The first use or replacement of the worm pair or reduction gear pair, after 150-400 hours of operation, replace the lubricant, the subsequent oil change period is less than or equal to 4000 hours. 3. Check the amount and quality of the oil regularly, save enough lubricating oil, and replace the oil mixed with impurities or metamorphosis in time. 4. The oil injection quantity should be mixed according to the requirements, and the oil of different grades should be mixed. The oils with the same grade and different viscosity are allowed to be mixed. 5. Check the amount and quality of the oil regularly, save enough lubricating oil, and replace the oil mixed with impurities or metamorphosis in time.
I hope that the above maintenance methods can bring you assistance. I also hope that everyone can treat the reducer like the car, so the service life of the reducer is extended, and your production efficiency is also going up.