Why does the worm gear reducer generate vibration?

Worm and worm reducers are also made of different materials. The bearing force and weight vary with the material of the reducer housing. The internal parts of the worm gear reducer are all metal castings, so they are relatively heavy. Especially the cast iron worm gear reducer made of cast iron is much heavier than the aluminum alloy worm gear reducer made of aluminum alloy. The aluminum alloy worm gear reducer is relatively light. Cast iron worm gear reducer has horizontal installation and vertical installation, and aluminum alloy worm gear reducer is suitable for multi-directional installation. Why does the worm gear reducer generate vibration?

The following sections analyze several reasons why the worm gear reducer vibrates:

1. Because the connection part between the worm gear reducer and the motor is not vertical, resonance occurs, and the motor must be removed and installed again.

2. If the output shaft connected with the worm gear reducer is bent or deformed, the coaxiality of the output drive shaft must be measured.

3. If the middle height of the equipment transmission shaft is inconsistent with that of the worm gear reducer, the installation surface of the worm gear reducer must be adjusted to ensure that the two installation dimensions of the equipment transmission shaft and the worm gear reducer are equal.

The above are the reasons that may cause the vibration of the worm gear reducer. It is suggested that we should do a good job in the maintenance and inspection of the daily reduction motor, so that we can find and deal with problems in a timely manner. Correct use and installation of worm gear reducer motor can reduce faults