How to Determine Whether the Motor Rotation Direction of the WPO50-20-B Worm Gear Reducer is Correct
Step 1: Confirm the direction of rotation of the worm gear firstThe WPO series gearbox defaults to using a right-handed worm gear, which is a common configuration in the industry and can be quickly verified on site
1. Vertically raise the worm axis and observe the direction of thread inclination

2. The inclination of the thread to the upper right is called right rotation, and the inclination to the upper left is called left rotation
3. The rotation direction of the worm gear must be completely consistent with that of the worm gear to ensure correct meshing and transmission
2、 Step 2: Use the left and right hands to determine the standard turning direction
The worm gear of this model is the active component, and the motor directly drives the input end of the worm gear. Operate according to the following rules:
1. The rule for using the right hand directly with a right-handed worm gear is: extend your right hand and bend all four fingers in the same direction as the rotation direction of the worm gear driven by the motor
2. The thumb extends straight and points towards the axial force direction of the worm gear, while the tangential velocity direction at the meshing point of the worm gear is opposite to the direction pointed by the thumb
3. Directly derive the standard rotation direction of the output shaft from this, and compare it with the required steering of the equipment to determine correctness
3、 Step 3: Final verification of no-load testing
This is the most secure verification method on site, completely avoiding the positional deviation of theoretical judgments:
1. Disconnect the output end of the gearbox from the load to ensure no additional resistance
2. Instantly power on the jog motor and observe the actual rotation direction of the output shaft
3. If the steering matches the equipment process requirements completely, it means that the motor steering is correct; On the contrary, changing the wiring of any two phases of the motor can correct it
4. The reduction ratio of this model is 20, and the output shaft rotation amplitude is small when jogging, which will not cause internal meshing impact and has high safety
4、 Key precautions
1. When making the judgment, it is necessary to combine the horizontal installation structure of the model with the worm gear at the bottom and the worm gear at the top to avoid misjudging the steering due to relative position
2. Long term operation with incorrect steering can lead to meshing wear, abnormal temperature rise, and even failure of reverse self-locking function. Verification must be completed before carrying the load
3. If it is not possible to directly observe the worm gear on site, you can refer to the output shaft steering arrow marked on the equipment nameplate and compare it with the measured results to quickly confirm