The relationship between gears and reducers
A reducer uses the transmission of gears at all levels to reduce speed.
Advantages and disadvantages of gear reducers and turbine reducers
As we all know, a turbo reducer is a universal reducer suitable for many motors. Due to its convenient installation, low cost, and wide coverage of motors, it has been favored and favored by many mechanical manufacturers. So, what are the advantages and disadvantages of each gearbox?
Broken teeth of cylindrical gear reducer
Tooth breakage is a common fault in gears, and the fracture of transmission gears usually occurs on the teeth. Due to the high stress at the teeth, it is the source of stress. There are three common conditions for broken teeth:
Maintenance of Hardened Gear Reducer
The installation method of hard tooth surface gear reducers is a key component of the application and maintenance of hard tooth surface gear reducers. It ensures the normal operation of industrial equipment, the ratio of computer installation speed to computer installation
Method of Preventing Deformation of Servo Planetary Reducer
1. If gears need to be drilled to reduce weight, then we should arrange the drilling procedure after heat treatment.
Why do servo motors have planetary reducers
Servo motors are equipped with reducers to increase torque. It is not economical to blindly increase the power of the servo motor when the load is high. Therefore, select the appropriate reduction ratio reducer in the required speed range. The reducer itself is used to reduce speed and increase output torque. Connection mode between reducer and motor: Hold mode - Output shaft of servo motor extend
Shaft breakage due to too little output of reducer
If the drive motor is not broken, but the output shaft of the reducer is broken, there are several possible causes besides poor concentricity of assembly at the output of the reducer. First, the wrong selection results in insufficient output of the gearbox. Some users mistakenly assume that as long as the rated output torque of the selected reducer meets the requirements of the work, it is not.
Why is there noise in planetary deceleration opportunities
Why is there noise in planetary deceleration? What is the solution? Traditionally, the three main factors that measure the performance of a gearbox are the load-bearing capacity and operating accuracy of fatigue life, but these factors often overlook transmission noise. The competition for reducer products in the modern mechanical processing industry is becoming increasingly fierce. Noise is an im