How to Determine the Coaxial Misalignment of the Internal Shaft System in NGW62-22.4 Planetary Gearbox
1、 Static disassembly detection (core judgment method)Reference inspection of housing bearing holes: Completely disassemble the reducer, clean the oil and burrs on the surface of each level of bearing holes in the housing, use a precision spindle with a dial gauge to measure the coaxiality of the high-speed shaft bearing hole, intermediate stage planetary carrier bearing hole, and low-speed output shaft bearing hole. If the radial runout difference value exceeds 0.05mm, it is judged to be out of tolerance.
Single inspection of shaft parts: Place the input sun gear shaft and planetary carrier output shaft on V-shaped blocks respectively, rotate the shaft body once, and use a dial gauge to measure the radial full runout of the shaft neck at both ends of the shaft. If the runout exceeds 0.03mm, it indicates that the shaft itself is bent and coaxial out of tolerance.

Verification of planetary carrier pin holes: Check the coaxiality of the planetary pin holes on the two end plates of the planetary carrier. Insert the inspection shaft into the corresponding pin hole, and if the reading difference on the dial gauge exceeds 0.04mm, it is determined that the pin hole system is coaxial and out of tolerance.
2、 Dynamic running feature verification (non disassembly assisted judgment)
Vibration spectrum characteristics: When collecting vibration data during no-load operation, if the energy of the first harmonic vibration exceeds 60% and the vibration acceleration level is 5-8dB higher than the normal value, it indicates that the coaxial deviation of the shaft system causes dynamic imbalance.
Abnormal temperature rise of bearings: After continuous operation for 2 hours, the temperature of the internal supporting bearings exceeds 70 ℃, and the temperature difference between different bearing seats is greater than 15 ℃. After excluding the factor of insufficient lubrication, it can be determined that the axial system is overloaded due to coaxial deviation.
Gear meshing abnormal noise: Use a stethoscope to press against the housing and hear periodic dull impact sounds. There is a noticeable jerking sensation when turning, indicating that the coaxial deviation of the shaft system is causing gear meshing unbalanced load.
3、 Standard threshold comparison and judgment
The coaxiality of the internal shaft system of this model follows the JB/T 6502-2015 standard, and the core judgment caliber is as follows:
1. The coaxiality tolerance of the axis lines of the two adjacent bearing holes in the casing is ≤ 0.03mm, which exceeds the tolerance.
2. The radial runout tolerance of the entire shaft neck is ≤ 0.05mm. If it exceeds this tolerance, it will be determined that the shaft itself is coaxial out of tolerance.
3. The coaxiality tolerance of the corresponding pin holes on both sides of the planetary carrier is ≤ 0.04mm, which exceeds the judgment of the coaxiality tolerance of the planetary carrier shaft system.