Speed ​​​​gear oil replacement steps

After the reducer gear oil has been used for a certain period, the reducer gear oil should be replaced in time. If the reducer gear oil is not replaced in time, expired or relatively turbid lubricating oil may cause the following conditions in the reducer: the bearing temperature will increase, The working temperature is too high, the noise becomes louder, the reducer leaks oil, and it generates abnormal heat, etc.

 The following is a brief introduction to the replacement steps of reducer oil and gear oil:

 1. The viscosity of the oil increases after cooling and it is difficult to drain the oil. The reducer should change the oil at operating temperature. 2. Cut off the power supply to prevent electric shock! Wait until the reducer cools down and there is no danger of burning! Note: The reducer should still be kept warm when changing the oil. 

3. Place an oil pan under the oil drain plug. 4. Open the oil level plug, breather and oil drain plug. 5. Drain all the oil. 6. Install the oil drain plug. 7. Inject new oil of the same brand. 8. The amount of oil should be consistent with the installation position. 9. Check the oil level at the oil level plug. 10. Tighten the oil level plug and breather.