What are the matters needing attention in the installation and maintenance of the gear reduction motor?

The installation and maintenance precautions for gear reduction motors include:

1. Please confirm whether the appearance of the gear reducer motor is damaged before use? Is there any oil leakage?

2. Please confirm in advance whether the specifications of the purchased gear reducer motor match the design specifications?

3. Please confirm the voltage used for the gear reduction motor first. If the voltage is unstable, a voltage regulator can be installed.

4. Please confirm the fixed base to avoid looseness during transmission operation.

5. If accessories such as pulleys, sprockets, and couplings are used, they must be installed in accordance with relevant regulations.

6. When the gear reducer motor is in operation, the rated current should not exceed the current value indicated on the motor nameplate.

7. Lubricating grease has been placed in the body of the gear reducer motor, and there is no need to change the lubricating oil after 12000 hours.

8. Please pay attention to surrounding temperature, humidity, acidity, and alkalinity issues.

9. The gear reducer motor is suitable for environments ranging from -10 ° C to+40 ° C, humidity below 90%, and indoor elevations below 1000 meters.

10. If not installed, maintained, or operated in the correct manner, it may cause serious injury to the gear reducer motor.

11. When repairing or disassembling, it is necessary to confirm that the external power supply is completely disconnected from the gear reducer motor.

12. Safety protection devices need to be installed to ensure absolute operational safety.

13. The motor needs to be grounded, please refer to the relevant distribution regulations.

14. Please confirm that all installation components and transmission accessories are fixed correctly before starting the gear reduction motor.

15. If the gear reduction motor is combined with a frequency converter for low speed transmission, an independent auxiliary cooling fan needs to be installed.

16. After the single-phase deceleration motor is powered off, there is still some residual charge in its capacitor. Please discharge it first or ground the terminal.