Industry-news

Here are some methods to ensure precise alignment between the output shaft and the screw shaft of the rubber screw extruder when installing the ZLYJ250-16-I reducer: Preparation and inspection before installation Check the dimensional accuracy of components: Accurately measure the diameter, length, keyway, and other dimensions of the output shaft of the reducer and the screw shaft of the rub

Loose screws can cause the following specific hazards to the operation of ZLY630-14-2 hard tooth reducer: Causing component displacement or detachment: Loose screws connecting key components such as the gearbox body, gear shaft, and bearing seat can cause changes in the relative position of these components, affecting the normal meshing of gears and the positioning of bearings. In severe cases,

When choosing an RV30-30-0.18KW aluminum alloy worm gear reducer, the following factors need to be considered: Technical Parameter Transmission ratio: determined based on the input speed and required output speed of the equipment. The transmission ratio of RV30-0.18KW reducer is 30, and it needs to be confirmed whether it meets the transmission requirements of the equipment. If the output sp

The output torque of NGW52-18 planetary gearbox is affected by various factors, such as motor power, input speed, and utilization coefficient. According to some data, the output torque range of the NGW series two-stage planetary gearbox is between 902-47305N · m. But for the specific NGW52-18 model, its output torque usually needs to be determined through the gearbox torque calculation formula bas

The installation dimensions of NGW61-6.3 planetary gearbox usually include the following key parts: Center distance: refers to the distance between the centers of the input shaft and the output shaft. For NGW61-6.3 planetary reducers, the center distance needs to be determined based on their specific structural design and transmission ratio, and is generally clearly marked in the design drawing

The common faults and solutions of SA87D112M4/4KW/86.15/M1/0 degree reducer are as follows: Leakage of oil Reason: Low coaxial accuracy between the reducer and the driving or driven device, resulting in oil seal and bearing wear; Damage to the sealing gasket and O-ring; Loose bolts on the joint surface; The lubricating oil has poor quality and contains a lot of impurities, which accelerates

The specific solution to the vibration of the SAF57-B0.75-4P-45.92 gearbox body is as follows: Alignment adjustment: check the alignment between the reducer and the drive motor or other connected equipment to ensure that their shafts are in the same straight line. If the alignment is poor, the installation position needs to be readjusted, and if necessary, professional alignment tools should be

In addition to the box structure, the following factors can also affect the performance of high-power H1SH industrial gearboxes: Materials and Manufacturing Accuracy of Gears In terms of materials, gears made of high-strength low-carbon alloy steel through carburizing and quenching have high tooth surface hardness, and the hardened layer has an ideal residual compressive stress distribution