News

The output shaft of BWY18-11-4KW cycloidal pinwheel reducer is a pin type force transmission special structure, which is adapted to the multi pin equal load and planetary meshing characteristics of cycloidal transmission. There are essential differences between the output shaft of gear reducer and worm gear reducer in terms of structural force transmission, material technology, size design, load a

The K77-Y11-4P-20.25 reducer is a hard tooth surface model with a power output of 11kW and a transmission ratio of 20.25. It uses a splash lubrication system, and its faults are often related to oil level control, oil quality, installation posture, and component wear. The common faults and causes are as follows: 1. Insufficient lubrication or excessive oil agitation caused by abnormal oil level

The splash lubrication system adapted to the K57YVP100l4/3KW/13.25/M6 reducer is a passive structure that relies on gear rotation with oil and oil throwing to achieve lubrication. It is suitable for the working conditions of this model, including 3kW power, 13.25 transmission ratio, and M6 flange installation. Its advantages and disadvantages are as follows: 1. Simple structure and high reliabi

The RF57-5.05-3kW reducer belongs to the R series hard tooth helical gear reducer, which is compatible with 3kW motors and has a reduction ratio of 5.05. It has the characteristics of compactness, high efficiency, and impact resistance. It is widely used in the chemical industry as a transmission system for small mixing tanks, metering pumps, powder conveyors, and additive proportioning devices. D

The ZL115-8 gear reducer belongs to the ZL series two-stage cylindrical gear reducer. In the model, "115" represents the final center distance of 1150mm, and "8" represents the nominal transmission ratio of 8. According to JB/T 8853-2015 "Cone Gear Cylindrical Gear Reducer" and practical application experience, its applicable working conditions are as follows: 1. Speed and motion conditions

BLEY52-841-1.5 belongs to a double cycloid gear needle wheel reducer. After replacing the cycloid gear, precise adjustment is required to ensure that parameters such as phase, meshing clearance, and axial displacement meet the requirements, avoiding transmission jamming, excessive noise, insufficient torque, and other faults. The specific adjustment steps are as follows: 1. Phase review adjustm

The selection of BLEY2215-391-1.1kW cycloidal pinwheel reducer is based on its characteristics of large reduction ratio, small volume, high torque, and low speed, which are highly matched with the requirements of low-speed heavy load, limited installation space, and high operational stability. The specific applicable scenarios and selection criteria are as follows: 1. Small and medium-sized equ

The RF77D132M4-7.5-5.2 reducer is commonly used in printing equipment because its performance parameters, structural characteristics, and working conditions are highly matched with the requirements of the printing equipment. Specific analysis can be conducted from the following aspects: 1. The core requirement for power and speed ratio adaptation in printing transmission This model is compat