Industry-news

Abnormal oil level can directly change the fluid dynamics state inside the gearbox: if the oil level is too high, it will produce a high-frequency "buzzing" sound accompanied by temperature rise due to vigorous oil stirring, while if the oil level is too low, it will cause lubrication failure at the gear meshing point, resulting in dull "clicking" impact sound or sharp friction sound, both of whic

WPDZ80-30-B is a vertical, single-stage, cast iron worm gear reducer, belonging to the domestic standard WP series, commonly used in small and medium-sized equipment that requires large reduction ratios, smooth transmission, and self-locking. 1、 Model meaning (WP series standard) W: Worm (worm gear) P: Plane (Flat Box, WP Series) D: Foot installation (with base) Z: Vertical (input s

The presence of scratches on the shaft surface of the DFYK360-500-A1 reducer is mainly determined through a combination of visual inspection and observation of the operating status. Due to the fact that this model belongs to the hard tooth surface cylindrical gear reducer series produced by Jiangsu Tailong, its shaft surface (especially the input/output shaft and key connection parts) may experien

Whether the oil level of the DBY280-10-IS gear reducer is appropriate can be checked by stopping the machine and cooling it down, and then checking the oil level gauge or oil level inspection hole. The oil level should be between the "highest" and "lowest" marks as normal. This model is a hard toothed cylindrical gear reducer commonly used in heavy-duty transmission systems. The oil level directly

ZSY400-22.4-VI gear reducers are usually paired with elastic pin couplings or gear couplings, which can effectively compensate for the coaxiality deviation between the motor and the reducer, and meet the requirements of transmitting high torque and operating at medium to high speeds. According to the design characteristics of ZSY series reducers, elastic pin couplings are commonly used at the i

The detection methods for the bending of the output shaft of the cycloidal pinwheel reducer mainly include dial gauge measurement, micrometer measurement, visual inspection, and vibration analysis. Among them, the dial gauge measurement method is the most accurate and commonly used. 1. Visual inspection method: Place the output shaft on a flat surface and observe whether its surface is flat or

Whether the H3SH3E gearbox is normal can be comprehensively judged by operating temperature, vibration, abnormal noise, and regular professional testing. 1. Temperature monitoring Measure the surface temperature of the bearing seat using an infrared thermometer. Under normal circumstances, the temperature should be 30 ℃ lower than the ambient temperature, and the temperature difference on both

If the ventilation hole is blocked, it will affect the internal pressure balance of the gearbox, causing lubricating oil leakage or seal damage. Timely cleaning is crucial. To clean the ventilation holes of XLED0.55-53-3481 cycloidal pinwheel reducer, the following steps can be followed: 1. Shutdown cooling Ensure that the gearbox has stopped running for more than 30 minutes, and wait for t