News

At present, there is no specific research or data on the efficiency changes of ZQD400-100-81.7 gear reducer under different humidity environments. However, the general principles and characteristics of gear can be used to analyze its efficiency changes under different humidity environments. Low humidity environment In low humidity environments, the impact on the efficiency of the gearbox is g

The meaning and features of the helical gear SA47-YVP0.37-4P-24.77-M1 worm gear reducer

Installation and maintenance of the hard-tooth surface SA67-9.17-4KW gear reducer

Connect the motor and reducer: Connect the motor and reducer naturally, and do not knock them. Ensure that the coaxiality between the motor output shaft and the gearbox input shaft is consistent, and that the outer flanges of both are parallel. Inconsistent alignment or non parallel flanges on both sides can cause the motor shaft to break or the gear of the reducer to wear. Connect it properly a

The common faults and solutions of ZLY400-8-2 hard tooth reducer are as follows: Excessive noise Gear and bearing wear: After long-term use, the surface of gears and bearings may experience wear, resulting in a decrease in meshing accuracy and the generation of noise. The solution is to regularly check the wear of gears and bearings. If the wear is severe, it needs to be replaced in a timely

Here are the specific parameters of the ZDY400-4-5 gear reducer:

The following is the general installation process for the cooling fins of JZQ250-10.35-9 reducer with soft tooth surface: preparation Confirm parts: Check whether the model and specifications of the heat sink match the gearbox, and whether there are any defects such as damage or deformation. At the same time, prepare the necessary bolts, nuts, washers, and other connectors for installation,

How to improve the heat dissipation conditions of RF87-216.54-0.75KW hard tooth gear reducer