News

Here are some methods to address the impact of thermal expansion and contraction on the clearance of ZSCA600-27.3-2 hard tooth reducer: Reasonably adjust the bearing clearance: adopt a shaft system structure with one end fixed and one end moving, and use the end with smaller radial force as the moving end to reduce the frictional force during axial movement. The fixed end bearing bears axial fo

The load testing of planetary gear reducers usually has a common process and method. The following is the general standard process for load testing: 1. Preparation before testing Installation and debugging: Install the NGW102-16 planetary gear reducer correctly on the test bench, ensuring that the installation is firm and the connecting components are not loose. Adjust the coaxiality of the

In the load test of NGW112-8-31.5 planetary gear reducer, the following aspects can be used to determine whether the equipment or system has malfunctioned: Abnormal sound: If the gearbox makes sharp and piercing whistling sounds, irregular knocking sounds, or other abnormal noises during operation, it may be due to poor gear meshing, damaged bearings, or foreign objects entering the interior, i

If there is abnormal noise during the trial operation of a large hard tooth reducer after maintenance, the following methods can be used to handle it: Shutdown inspection: The equipment should be stopped immediately to prevent possible further damage. After the gearbox cools down, conduct external observation and preliminary auscultation to determine the approximate area of the noise source.

The heat treatment process has a significant impact on the noise level of DFY560 gear reducer, as follows: Affects the performance of gear materials Hardness and wear resistance: Appropriate heat treatment, such as surface quenching, carburizing quenching, etc., can improve the hardness of the tooth surface, reduce wear and plastic deformation during meshing, and thus reduce noise caused by

When cleaning the DCY224-20-IV hard tooth gear reducer, the following precautions should be taken: Safety preparation: Before cleaning, be sure to disconnect the power supply of the reducer and separate it from other equipment to prevent accidental start-up and personal injury. Personal protection: Operators should wear personal protective equipment such as safety goggles, gloves, dust masks

The cleaning work of DCY800-25-1 hard tooth gear reducer is usually carried out by the following personnel: Equipment operator: Operators use reducers on a daily basis and have a good understanding of their operating status and appearance. They are responsible for cleaning the dust and debris on the surface of the reducer housing before and after equipment operation or during daily inspections,

In the load test of NGW101-3.15 planetary gear reducer, the accuracy and reliability of the data can be ensured by the following methods: Selection and calibration of testing equipment: Choose high-precision sensors: such as using high-precision torque speed sensors and temperature sensors to monitor the operating parameters of the gearbox in real time. Ensure that the torque measurement ran