The BWED142-391-3KW cycloidal pinwheel reducer usually adopts oil bath lubrication method. The oil volume of its lubrication system can be controlled by referring to the following methods: Oil level standard: The oil level should be kept at 1/2 to 2/3 of the oil window or just below the plastic oil cup. There is also a standard that the oil level should be around 2mm from the centerline of the
When the lubrication system of XL10-71-15KW cycloidal pinwheel reducer has abnormal oil quality and quantity, abnormal temperature, increased noise and vibration, and oil leakage, it needs to be checked in a timely manner. Specifically, as follows: Deterioration of oil quality: If the lubricating oil turns black, turbid, or has obvious impurities, it indicates that the oil quality has been cont
The common causes of oil leakage in the lubrication system of XLD2-0.55-29 cycloidal pinwheel reducer include sealing problems, improper installation and maintenance, abnormal oil volume, box problems, and harsh operating conditions, as follows: Aging or damage of seals: After prolonged use, seals such as oil seals and bearing seals may lose their sealing properties due to wear and aging, leadi
The main reasons for abnormal vibration of ZJY250-15-S shaft mounted gear reducer are mechanical failure, improper installation, lubrication problems, etc., as follows: Mechanical component failure: Gear problem: Gears are prone to wear, pitting, peeling, or cracking after prolonged operation, which can lead to a decrease in meshing accuracy and vibration. In addition, low precision in gear
During the installation process of VF series worm gear reducer, the following tools are usually required: Tightening tool: A wrench is an essential tool used to tighten or loosen bolts and nuts. Depending on the size of the gearbox bolts, a ring wrench, socket wrench, etc. can be selected. If it involves some smaller screws, a screwdriver is also needed. Measuring tool: A level is used to en
To determine whether the durability verification test results of the gear reducer are qualified, the following standards can be used: Gear wear condition: In a test of 2000 hours of full load operation, it is necessary to monitor the amount of tooth surface wear, which generally requires a small amount of wear. For example, after a 20000 hour acceleration life test of a planetary gearbox, the a
To determine whether the vibration of the ZJY212-16-22KW shaft mounted reducer is abnormal, the following aspects can be taken into account: Reference vibration standard: According to the Chinese national standard GB10068-2008 "Measurement and Evaluation of Mechanical Vibration Velocity and Acceleration", the standard value of the vibration velocity of the reducer is 0.45mm/s, and the standard
In addition to the measures mentioned above to improve the working environment, the performance of gear reducers can also be improved through optimizing design, improving manufacturing and assembly accuracy, and improving lubrication, as follows: Optimize gear design Choose the appropriate tooth profile: In addition to the common involute tooth profile, the involute tooth profile or circular
