News

Axial movement can directly lead to performance degradation and efficiency loss of RX79-2.43-5.5KW-M1-0 ° gearbox from the two core dimensions of "power transmission" and "operational stability", and may also cause chain failures in the long run. 1. The power transmission performance deteriorates, and the output accuracy and stability decrease Axial movement can disrupt the normal meshing relati

Based on the vibration state of WPW40-25 worm gear reducer, it is necessary to comprehensively analyze the fault type by combining the vibration characteristics and related parameters. The specific method is as follows: 1、 Basic vibration parameter detection 1. Vibration amplitude measurement Use a vibration tester to detect displacement, velocity, or acceleration. The normal vibration veloci

To replace the cooling fan of the WPDKS80-30-1.5KW worm gear reducer, the process of "safe power-off → disassembly of the old fan → matching of the new fan → installation and reset" should be followed. The core is to ensure correct wiring and firm installation to avoid heat dissipation failure caused by model mismatch or improper installation. 1、 Preparation before replacement: Confirm the model

There is no fixed answer to this question. The remaining operating time of the BLD13-23-5.5KW cycloidal pinwheel reducer after a lubrication system failure depends entirely on three core factors: the type of fault, load conditions, and ambient temperature. The difference can range from a few minutes to several hours, with significant variations. 1. The type of fault determines the underlying risk

The methods for checking the side clearance of SCWS200-20-IF worm gear reducer mainly include feeler gauge method, dial gauge method, and lead pressure method, as follows: Feeler gauge method: First, clean the meshing teeth of the reducer to ensure that there are no oil stains, impurities, or other factors that affect the measurement. Then use a feeler gauge to directly insert between the meshi

Optimizing the coaxiality between the motor shaft and the input shaft of SCWS225-40-F worm gear reducer requires precise alignment and adjustment. The specific steps are as follows: 1、 Preparation before installation Basic inspection Ensure that the installation base is flat and firm, the pre tightening force of the anchor bolts is uniform, and avoid axis deviation caused by foundation defo

The core parameters and applicable scenarios of NBZD250-71-1 planetary gear reducer are as follows: 1、 Key technical parameters: Machine base number (250): Corresponding to a center distance of about 250mm for the equipment, the size and load-bearing capacity of the casing are fixed, and it is usually matched with a motor power range of 15-45KW (please refer to the manufacturer's sample for

The core vulnerable parts of planetary gearboxes are planetary gears, sun gears, and bearings, and daily maintenance requires targeted protection: 1. Regular inspection and oil change Oil level and quality: Check the oil level once a week and the oil quality once a month (observe the oil color, if it turns black, has impurities, or emulsifies, it needs to be replaced immediately). Oil cha