BLED121-493-0.75KW cycloidal reducer experiences excessive vibration during load debugging. The following methods can be used to solve the problem: Installation and connection aspects Tighten the anchor bolts: Check if the anchor bolts are loose. If they are loose, use appropriate tools to tighten them to the specified torque. If necessary, add elastic washers or use double nuts to prevent t
The excessive vibration during load debugging of BLED120-187-1.1KW cycloidal reducer may be caused by the following reasons: Installation and connection issues Loose foundation bolts: Long term operation may cause loose or damaged foundation screws, resulting in unstable fixing of the reducer and vibration during load debugging. Coupling failure: Improper installation of the coupling, exc
Here are some materials that may be used when installing and maintaining B3SH9-50-90KW high-power gearboxes: 1. Lubricating oil: Select suitable lubricating oil according to the working requirements of the gearbox, such as industrial gear oil with high viscosity index, good wear resistance, and oxidation resistance. Common brands include Shell, Mobil, etc. 2. Seals: including various specifi
KAT97R57- YVP2.2-258 The abnormal heating of the gearbox may be caused by the following faults: Lubrication issues: Excessive lubricating oil: It can cause power loss during oil agitation, resulting in a large amount of heat generation. Insufficient lubricating oil: causing increased friction between transmission components and generating a large amount of heat. Oil quality issues: Oil
The common faults and solutions of SA87D112M4/4KW/86.15/M1/0 degree reducer are as follows: oil leakage Reason: Low coaxial accuracy between the reducer and the driving or driven device, resulting in oil seal and bearing wear; Damage to the sealing gasket and O-ring; Loose bolts on the joint surface; The lubricating oil has poor quality and contains a lot of impurities, which accelerates the
The specific solution to the vibration of the SAF57-B0.75-4P-45.92 gearbox body is as follows: Alignment adjustment: check the alignment between the reducer and the drive motor or other connected equipment to ensure that their shafts are in the same straight line. If the alignment is poor, the installation position needs to be readjusted, and if necessary, professional alignment tools should be
The installation steps of ZLYJ250-16-I reducer on rubber screw extruder are as follows: Preparation before installation Check whether the appearance of the reducer is intact, whether all components are complete, and whether there is any damage caused during transportation. Prepare the necessary tools for installation, such as wrenches, screwdrivers, level gauges, feeler gauges, lifting equi
Here are some methods to ensure precise alignment between the output shaft and the screw shaft of the rubber screw extruder when installing the ZLYJ250-16-I reducer: Preparation and inspection before installation Check the dimensional accuracy of components: Accurately measure the diameter, length, keyway, and other dimensions of the output shaft of the reducer and the screw shaft of the rub
