Industry-news

The working environment temperature of WPDA120-50:1-B worm gear reducer is generally -40 ℃ -+40 ℃. When the working environment temperature is below 0 ℃, the lubricating oil must be heated to above 0 ℃ before starting. When the working environment temperature is above 40 ℃, cooling measures must be taken. as follows: Protective measures when the temperature is too high Upgrade related componen

The working principle of the lubrication system for high-power B3SH9-Y280-50-90 gearbox is similar to that of a general high-power gearbox lubrication system, mainly including the following aspects: Oil supply mechanism: The lubrication system is supplied with oil by both electric and mechanical pumps, ensuring that the lubricating oil can be continuously and stably delivered to various lubrica

The solution to the abnormal vibration of ZJY75-22.4 shaft mounted reducer can be approached from the following aspects: Check the installation foundation and connections Tighten the foundation bolts: Check if the bolts on the reducer base are loose. If they are, use the corresponding tools to tighten them to the specified torque to ensure that the reducer is installed firmly. Adjust inst

To effectively reduce the oil tank temperature of R87RF58-1037-0.18KW reducer, the following aspects can be taken into consideration: Improve lubrication conditions Choose the appropriate lubricating oil: Based on the working conditions and performance requirements of the gearbox, choose lubricating oil with good lubrication performance, thermal stability, and oxidation resistance. For examp

The working principle of the R97R57DT80N4-1:632-0.75KW reducer oil cooling or water cooling system is mainly to reduce the temperature of the reducer through the circulation of lubricating oil and heat exchange with the cooling medium (air or water), as follows: Working principle of oil cooling system: There is an oil tank inside the reducer, and the oil pump is located in the oil tank. The oil

To determine the bearing service life of TY200-35.5-22KW hard tooth gear reducer, it is necessary to comprehensively consider multiple factors and apply corresponding calculation methods and empirical data. The following is a specific introduction: Determination of Bearing Service Life Basic rated life calculation: According to ISO 281 standard, the basic rated life of a bearing (unit: milli

To determine the service life of the sealing components for TY224-63-37KW hard tooth gear reducer, the following is a specific introduction: Estimation based on experience and working conditions: The service life of seals is closely related to factors such as working conditions and materials. For example, seals made of nitrile oil resistant rubber have a 50% reduction in lifespan for every 15 ℃

When abnormal noise is found in the ZSY200-56-I gear reducer, the following steps can be followed for maintenance: 1. Immediate shutdown inspection: If any abnormal noise is found in the gearbox, the equipment should be stopped as soon as possible to avoid further damage caused by continuing to operate in an abnormal state. At the same time, cut off the power to ensure safety during inspection