Tooth breakage is a common fault in gears, and the fracture of transmission gears usually occurs on the teeth. Due to the high stress at the teeth, it is the source of stress. There are three common conditions for broken teeth:
The installation method of hard tooth surface gear reducers is a key component of the application and maintenance of hard tooth surface gear reducers. It ensures the normal operation of industrial equipment, the ratio of computer installation speed to computer installation
1. If gears need to be drilled to reduce weight, then we should arrange the drilling procedure after heat treatment.
Servo motors are equipped with reducers to increase torque. It is not economical to blindly increase the power of the servo motor when the load is high. Therefore, select the appropriate reduction ratio reducer in the required speed range. The reducer itself is used to reduce speed and increase output torque. Connection mode between reducer and motor: Hold mode - Output shaft of servo motor extend
If the drive motor is not broken, but the output shaft of the reducer is broken, there are several possible causes besides poor concentricity of assembly at the output of the reducer. First, the wrong selection results in insufficient output of the gearbox. Some users mistakenly assume that as long as the rated output torque of the selected reducer meets the requirements of the work, it is not.
Why is there noise in planetary deceleration? What is the solution? Traditionally, the three main factors that measure the performance of a gearbox are the load-bearing capacity and operating accuracy of fatigue life, but these factors often overlook transmission noise. The competition for reducer products in the modern mechanical processing industry is becoming increasingly fierce. Noise is an im
The gearbox is a widely used industrial product, and its performance can be comparable to other military grade gearbox products. And the price and planetary reducers, these two countries with industrial grade products, are widely used in East and North China regions and industrial occasions. It can also be used as a support component for industries such as lifting, excavation, transportation, and
If the oil quantity is determined to be large compared to the actual oil quantity when the reducer is running, it is recommended to weigh the oil quantity and add an appropriate amount of smooth oil for the worm gear reducer when the reducer is finished running.
