WS280-63-4F Worm Gear Reducer Maintenance Guide 1. Daily inspection and basic maintenance Oil level and quality monitoring: Daily check the oil level to submerge the worm gear root, observe the oil quality color every week (normally amber), and if it turns black or contains metal shavings, immediately replace it with special lubricating oil (such as L-CKE/P 220). Temperature and noise contr
The WS80-23-II worm gear reducer has the following characteristics in material selection: Worm material: Medium carbon steel or medium carbon alloy steel, such as 45 steel, 40Cr, etc., are usually selected. These materials have good comprehensive mechanical properties and can meet the requirements of worm gear after appropriate heat treatment. For example, quenching and tempering treatment can
Maintenance points of WB85-LD370-43 micro cycloidal reducer The maintenance of this model of reducer (WB85 base number, LD370 speed ratio 43) needs to be combined with the general specifications and specific working conditions of the cycloidal pinwheel reducer. The following are the key maintenance steps: 1. Lubrication management Lubrication method: Priority should be given to using lubric
Choosing the WB series micro cycloidal reducer model that is suitable for one's own equipment requires comprehensive consideration of multiple factors. The following are the specific steps and key points: 1. Determine power requirements: Firstly, clarify the power requirements of the driven equipment. Calculate the required driving power based on parameters such as equipment workload and operat
The model "TJQ9-B7" should be "TJQ9" (compatible with B7 reducer, output shaft diameter 110 mm). Core parameters (TJQ9) Compatible reducer: B7 Output shaft diameter: 110 mm Input interface: 650 × 590 × 520, bolt 12-M22 (22 × 12) Output interface: 560 × 650 × 700, bolt 12-M27 (28 × 10) Installation related: H ≈ 955, H1 ≈ 210, H2 ≈ 420; Keyway 160 × 200, key 12 × 100 (common) Sele
When selecting the appropriate number of gearbox stages for a specific application scenario, it is important to evaluate the following load characteristics: 1、 Load type and impact characteristics Constant load Uniform loads such as fans, water pumps, etc. can be met by single-stage reducers with high transmission efficiency (95% -98%) Attention should be paid to controlling the load rat
The optimization of the operating state of gear reducers is the core means to improve their efficiency, extend their lifespan, and reduce the risk of failure. It requires systematic measures from five dimensions: design matching, lubrication management, structural improvement, operation monitoring, and maintenance. Specific measures can be broken down as follows: 1、 Optimizing design and selectio
To determine whether the alignment of a multi-stage reducer is good, the core is to detect the relative positional deviation (including parallelism and coaxiality) of the input shaft, intermediate shafts, and output shaft axes, as well as the alignment between the shaft and the coupling (or motor shaft) - poor alignment can lead to gear misalignment, bearing overheating, abnormal vibration, and lo
